ATC SunRay RF, Инструкция по установке и эксплуатации

Страница: 7 / 16

7
Power Monitor
Installation (Must be performed by an electrician)
Switch off the power supply to your control panel.
If you have various circuits, disconnect the
circuit breaker where you are going to make the
connection.
• To operate correctly the Gateway needs an Internet
connection via a broadband router. The equipment can
operate with broadband networks, cables and others, and in
most cases, no set up in the router is necessary.
• If there are any connection problems or if operating in
a corporate network, check with an IT technician that the
following requirements are met. As a general rule it is not
necessary to modify these parameters in a domestic router:
»
The DHCP server in the router must be activated.
»
There must be a direct Internet connection, without
passing through a proxy.
»
The output ports must be open:
˃ 123 UDP
˃ 5000 TCP
Requirements for correct operation
Installation instructions
TEST
OFF
ON ON ON ON ON ON ON ON