10
l) Choose
ON
or
OFF
by using (+PRG) or (-MAN) to scroll between the two
chooses and (OK) to enter the choose (the numbers at the top represent the
days of the week by the number
1 = Monday
and the
7 = Sunday
)
m) Once the last day has been entered the word
ADD
is displayed and the two
indicator bars will increase from left to right on the display and once the
program has been saved the unit will say
ADD
with no indicator bars
illuminated at the bottom of the screen
n) Press (OK) button, (will go back to the PR.XX screen the difference this time
is that the numeric values has increase by one: example
PR.01
when you
entered the first program but now the display will read
PR.02
)
o) Press (OK) button again, (now the display reads either
CH01
or
CH02
depending on which output you entered in the last program)
p) Choose the same output as before so then you can enter a stop time for the
output
q) Press (OK) button, (
Out
should be displayed on the screen just like in step f
except the word
OFF
should show up in the upper left corner, [Note - If the
screen doesn’t look like this than scroll with (+PRG) or (-MAN) buttons until it
does and also sign will not be illuminated]
r) Press (OK) button
s) Now repeat steps I through M to enter the time of day and which days of the
week you want to turn the corresponding output off ( Note: make sure to
choose the same days of the week to be
ON
in step J has you did in the
previous program set up)
t) Once programming is complete and the word
ADD
is again displayed and
you are finished adding programs than just hit the (MAN 2/ESC) button twice
to exit back to original run mode, (the indicator bar that goes with the
corresponding output should be illuminated at the button only on times where
the output it to be on for that day)
4.) Pulse Mode
This mode will give an output pulse time during a set time and days
of the week that is programmed. More than one output pulse can be given
in a day by adding a new program and using the pulse mode again. The
pulse length will be anywhere from 1 to 99 seconds long depending on the
predetermined time that was set in the, “
Cycle/Pulse Setting
”, section on
page 12.
a) Press and hold the (+PRG) button for 3 seconds,
is what
shows on the LCD display ( also you will see
prog
in the upper left corner of
the display)
b) Press the (OK) button to enter into the programming parameters (the word
ADD
will be shown now)
c) Press the (OK) button, (information about the number of the new program
Pr.XX) example:
this just gives a numeric values to the
memory location of this program
d) Now press the (OK) button, (
Ch01
or
Ch02
should display)
e) You can choose whether to control output 1 or output 2 by scrolling between
them with the (+PRG) or (-MAN) buttons
