-4-
ATC Electrical & Mechanical,
ATC House, Broomhill Drive, Tallaght, D24 EF99, Ireland
IE: 01 4678301, UK:0203 564 9164, Email [email protected]
SETTING THE DISPENSE AMOUNT
When the unit is turned on (see above), the amount of product dispensed can
be adjusted - default amount is 1.0ml.
To change the amount dispensed press and release the control button; each
time the button is pressed the LED will flash to inform the user what setting it
is on. 1 flash = 0.5ml, 2 flashes = 1.0ml etc.
There are 5 settings corresponding to 0.5, 1.0, 1.5, 2.0, and 2.5ml. After
reaching 2.5ml the next press returns to 0.5ml.
Note:
• Different liquid densities will have slight deviation from the above dispense
amounts.
• Each Time the dispenser is powered off, the dispense amount resets to
factory default (1.0ml).
TROUBLESHOOTING
Problem
Reason
Potential Solution
No LED Indicator
Control PCB Issue
Replace the control PCB
Batteries out of power
Change for new batteries
Poor contact in battery holder
Remove the batteries, clean the contacts and
replace the batteries in the holder
Indicator window dirty
Clean indicator window
LED Continuously
flashing
Low battery voltage
Change for new batteries
LED On without
product supply
Sensor is active
Check for reflective objects below unit and
remove them if present,
Check to ensure sensor window is clean
Insufficient
product supply
Short product supply time
Adjust the amount of product supplied
(See above )
Product is too thick to dispense
Change for less Viscous product
Product dried out internally
Try to operate with water to clear obstruction
To avoid blockages always prevent debris from entering the fluid container
SPECIFICATION
Power
DC9V (6x AA)
Sensing Distance
50-90mm (non adjustable)
Storage Volume
700ml
Liquid supply
0.5-2.5ml in 5 steps (adjustable)
Dimensions (HxWxD)
220x100x110mm Ambient Temperature 0-45°C
Net Weight
1.1kg
Liquid type
Liquid, Alcohol Sanitiser, Gel
WARRANTY
ATC Electrical and Mechanical provides a one year limited parts warranty for the Dahlia automatic dispenser
HANDSU as long as the unit has been installed, used and maintained in accordance with the information
provided in this manual.
In order to arrange parts for the dispenser the information listed below is required. It is recommended to
write this information below and keep this instruction manual in a safe place.
Serial Number:
Date of Manufacture:
Date
of
Purchase:
Location
Purchased:
