Version 1.0 10/2017
Product Manual—Wireless Video Bridge Gen2
V. INSTALLATION OPTIONS continued
B. WALL MOUNT INSTALLATION
continued
1. Determine location.
a. Ensure that the mounting location is free from hazards such as electric cables, wires, pipes, ducts, etc.
2. Drill pilot holes.
a.
If mounting in a stud partition wall:
Locate the studs in the wall. At least one of the mounting screws
should be attached to a wooden stud. (You should use an expansion anchor for any holes that are not
directly in a stud. Do NOT use the expansion anchor for any holes that are directly into a stud.)
b. Hold the mounting plate up (horizontally) to the wall and mark the location of the two pilot holes,
making sure they are level. The holes should be spaced 55mm (about 2.17") apart horizontally.
c. Drill two pilot holes 26mm (about 1") deep using a 3.6mm (1/8") drill bit. If using an expansion anchor, drill
that hole using an 8mm (1/4") drill bit.
d. For any holes using an expansion anchor, lightly tap the expansion anchor into the hole using a hammer.
3. Attach the mounting plate to the wall.
a. Place the mounting plate against the wall, aligning the holes.
b. Drive the screws through the mounting plate to be fastened and into the holes in the wall. (Step 1 below.)
4. Attach the unit to the mounting plate.
a. Align the two slots at the bottom of the unit with the two pins on
the mounting plate. (Step 2 below.)
b. Slide the unit until it locks in place. (Step 3 below.)
FIGURE 7: SLOTS FOR MOUNTING
FIGURE 8: ATTACHING THE MOUNTING PLATE
FOR WALL MOUNT INSTALLATION
Slots for mounting
11
