Operational Instructions
Troubleshooting
Page 13
Page 12
Press the
button on the front of the dock to increase the bass response.
Press again to cancel the Bass Boost function.
The UniStream includes a USB port on the back to allow you to charge your
media device. Make sure that UniStream is powered on and connect your
device using the USB cable (not included). Your media device will begin to
charge.
Note: Power output of the USB port is 500 mA. Media devices that require
more power may not charge through this USB port.
Bass Boost Control
Charging Your Device
AUX IN
USB
DC IN 5V
Symptom
Music is not
streaming over
Bluetooth
Music doesn’t
resume after
hanging up a call
No music control by
UniStream
No power
Solution
Verify UniStream is plugged in properly and into
a proper power source.
Make sure your Bluetooth device has A2DP
profile.
Check if both devices are paired and connected
over Bluetooth.
Make sure there isn’t a 3.5mm cable connected
to the aux input on the back of the speaker.
Restart the UniStream to auto-connect with
your Bluetooth device.
Press play to resume music.
Make sure your Bluetooth device has AVRCP
profile.
Remarks:
If troubleshooting does not eliminate the problem, disconnect the DC IN
plug from the back of the music dock and reconnect it after a few seconds.
This resets the music dock to it’s factory default settings and results in the
deletion of all previous settings. In case the problem still exists, see warranty
information on page 15 and page 16 to obtain service.
