TA B L E / D E S K I N S TA L L AT I O N
This telephone includes a 7-foot line cord with a
modular plug on each end. Use this cord to connect
the telephone to a modular jack.
1 . Fill in directory card
Remove the directory card and
write in your own telephone
number. Also write the tele-
phone numbers (or names)
that you want to store in each
memory location.
Reinstall the card and clear
plastic cover.
2 . Connect line cord to telephone
Plug the long line cord into the
jack on the underside of the tele-
phone base. Then feed the line
cord through the channel pro-
vided so the telephone sits flat
on your table or desk during use
(Figure 1).
3 . Connect line cord to wall jack
Plug free end of
the line cord into a modular
jack. Make sure it snaps firmly
into place.
4 . Set DIAL Mode switch
This product comes set in the
tone (TT) mode. Make sure you choose the
correct dialing method (TT/DP); touch tone dial-
ing will not work if you have dial pulse service.
5 . Connect handset to base
Plug one end of the coiled handset cord into the
handset, and the other end into the base. Then
hang up.
6 . Check for dial tone
Lift the handset and listen for dial tone. If you can-
not hear a dial tone, refer to “In Case of Difficulty”
and try to correct the problem.
TO DISCONNECT the telephone, squeeze the
clip on the modular plug and pull it out of the jack.
Figure 1
Figure 2
2
AT&T 230 Quark pdf 7/22/98 12:13 PM Page 3
