AT&T TL88002, Руководство пользователя

Страница: 10 / 38

Step 1
Plug the battery connector
securely into the socket
inside the handset battery
compartment. Insert the
supplied battery with the
label THIS SIDE UP facing
up, as indicated.
6
Battery installation and charging
Install the battery, as shown on pages 6-7. Once you have installed
the battery, the screen indicates the battery status (see the
following table). If necessary, place the handset in the telephone
base or charger to charge the battery. For best performance, keep
the handset in the telephone base or charger when not in use. The
battery is fully charged after 16 hours of continuous charging. See
the table on page 33 for battery operating times.
If the screen shows
Place handset in charger
and flashes, you
need to charge the handset without interruption for at least 30
minutes to give the handset enough charge to use the telephone
for a short time. The following table summarizes the battery
charge indicators and actions to take.
Getting started
Battery indicators Battery status Action
The screen is blank,
or shows
Place
handset in charger
and (flashing).
Battery has no or
very little charge. The
handset cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows
Low battery and
(flashing).
Battery has enough
charge to be used for a
short time.
Charge without interruption
(at least 30 minutes).
The screen shows
HANDSET X
.
Battery is charged. To keep the battery charged,
place it in the telephone base or
charger when not in use.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.
THIS SI
DE
UP / CE
CÔ
TÉ
VERS LE HA
UT
Batt
ery Pa
ck / Bloc-piles
:
BT1833
42/BT283342 (2.4V 400mAh Ni-MH)
WA
RNING /
AV
ERTISSEMENT
:
DO NOT BURN
OR
PUNCTURE BA
TTERIES
.
NE
PA
S INCINÉRER
OU PERCER LES PILES.
Made in
China / Fabriqué
en
chine BY
1021
THIS SIDE Battery Pack / Bloc
BT183342/BT2
83342
WARNING /
AV
ERTISS
DO NOT BUR
N OR PU
N
NE
PA
S INCINÉRER
O
Made in Chi
na / Fa