29
Getting started
Adding and registering a headset to an AT&T
DECT cordless telephone
To register a headset to an AT&T DECT cordless telephone base
You must first deregister the headset from
the headset base (see page 30).
Make sure the battery is properly installed in
the headset (see page 11). The
ON/OFF
light flashes twice every five seconds to
indicate the headset is not registered.
Place the headset in the headset base and
allow it to charge for at least five minutes
before beginning the registration. Leave
the headset in the headset base while
registering the headset.
On the telephone base of the cordless
phone, press and hold the
/
HANDSET LOCATOR
button until the
IN USE
light turns on (about four seconds)
and then release the button.
The headset is registered to the telephone
base automatically. It may take about 30
seconds to complete. The
IN USE
light on
the telephone base turns off. The headset
ON/OFF
light turns blue on the first
headset registered. The headset
ON/OFF
light turns orange on the second headset
registered. To verify the registration was
successful, press the
ON/
OFF
button and check for a dial tone.
NOTE:
If the registration fails, the
ON/OFF
light on the headset flashes
twice every five seconds. Reset the headset and try again. Remove the
headset from the headset base and press
ON/OFF
. Then place the headset
back into the headset base. Try the registration process again.
1.
2.
3.
4.
5.
