29
Troubleshooting
If you have difficulty with your telephone, please try the following suggestions. For
customer service, or to purchase accessories or replacement parts, visit our website
at
www.telephones.att.com
, or call
1 (800) 222-3111
. In Canada, dial
1 (866) 288-4268
. When you call customer service, you will need the serial
number or model number found on the bottom of the telephone base.
My telephone doesn’t work at all.
Make sure the power cord is securely plugged in.
Make sure that the battery connector is securely plugged into the cordless handset.
Make sure the telephone line cord is securely and firmly plugged into the
telephone base and the telephone wall jack.
Charge the battery in the cordless handset for at least 16 hours. For optimum daily
performance, return the cordless handset to the telephone base or charger when
not in use.
If the battery is depleted, charge the handset for at least 30 minutes before you
use it. Refer to
Battery charging
on page 6 for details.
Reset the telephone base. Unplug the electrical power. Wait for approximately 15
seconds, then plug it back in. Allow up to one minute for the cordless handset and
telephone base to reset.
You may need to purchase a new battery. Please refer to
Battery installation
on
pages 4-5.
The display shows No line. I cannot get a dial tone.
First try all of the suggestions, as mentioned above.
If the previous suggestions do not work, disconnect the telephone line cord from
your telephone and connect the telephone line cord to another telephone.
If there is no dial tone on that other telephone either, your telephone line cord
may be defective. Install a new telephone line cord.
If changing the telephone line cord does not help, the wall jack (or the wiring
to this wall jack) may be defective. Try using a different wall jack in your home
to connect your EL52106/EL52206/EL52256/EL52306/EL52346/EL52356/
EL52406 telephone, or contact your telephone service provider (charges
may apply).
I cannot dial out.
First try all the suggestions in
The display shows No line. I cannot get a dial tone
.
Make sure you have a dial tone before dialing. The cordless handset may take a
second or two to find the telephone base and produce a dial tone. This is normal.
Wait an extra second before dialing.
Check that all the telephones connected to the same telephone line are hung up.
Make sure to set the dial mode to the correct setting (pulse dialing or tone dialing)
for the service in your area.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•