5
Battery charging
Once you have installed the battery, the screen indicates the battery
status (see the table below). If necessary, place the handset in the
telephone base to charge the battery. For best performance, keep
the handset in the telephone base when not in use. The battery is
fully charged after 6 hours of continuous charging. See page 26 for
battery operating times.
If the screen is blank, you need to charge the handset without
interruption for at least 30 minutes to give the handset enough charge to use the
telephone for a short time. The screen shows
LOW BATTERY
until you have charged the
battery without interruption for at least 30 minutes. The following table summarizes the
battery charge indicators and actions to take.
Battery indicators
Battery status
Action
The screen is blank or shows
PLACE IN CHARGER
.
The battery has no or very
little charge. The handset
cannot be used.
Charge without interruption
until the screen shows
LOW BATTERY
or
HANDSET 1
(at least 30 minutes).
The screen shows
LOW BATTERY
and flashes.
The battery has enough charge
to be used for a short time.
Charge without interruption
until the screen shows
HANDSET 1
(at least
30 minutes).
The screen shows
HANDSET 1
and the battery icon shows
, or .
The battery is charged.
To keep the battery charged,
place it in the telephone base
when not in use.
NOTES:
If you are on a call in low battery mode, you hear four short beeps every 50 seconds.
When you place the handset in the telephone base, if no battery is installed in that handset, the
CHARGE
light is off and the screen shows
NO BATTERY
. Follow the instructions in
Battery installation
on page 4 to install the battery.
•
•
Battery status icon
11/20
HANDSET 1
16 MISSED CALLS
10:30
PM
