10
Getting started
Install the battery, as shown on page 11. Once you have installed
the battery, the screen indicates the battery status (see the
following table). If necessary, place the handset in the telephone
base or charger to charge the battery. For best performance, keep
the handset in the telephone base or charger when not in use. The
battery is fully charged after 10 hours of continuous charging. See
the table on page 36 for battery operating times.
If the screen shows
Put in charger
and
flashes
, you need to
charge the handset without interruption for at least 30 minutes to
give the handset enough charge to use the telephone for a short
time. The following table summarizes the battery charge indicators
and actions to take.
Battery indicators
Battery status
Action
The screen is blank, or
shows
Put in charger
and
(flashing).
Battery has no or
very little charge. The
handset cannot be
used.
Charge without interruption
(at least 30 minutes).
The screen shows
Low battery
and
(flashing).
Battery has enough
charge to be used for a
short time.
Charge without interruption
(at least 30 minutes).
The screen shows
HANDSET X
.
Battery is charged.
To keep the battery
charged, place it in the
telephone base or charger
when not in use.
Note: If you are on a phone call in low battery mode, you hear four short beeps every minute.
Battery installation and charging
