3-2
Installing Circuit Boards
________________________________________________________________________________________________
________________________________________________________________________________________________
________________________________________________________________________________________________
2. Complete the following steps a through f to install the VDC600 board:
a. Select an open 16-bit expansion slot as far to the left (on floor models, as far to the rear) as
possible.
b. Remove the screw from the metal cover of the expansion slot you selected (Figure 3-2). Lift
out the metal cover. Set the screw aside.
A
B
Figure 3-2. Removing the Expansion Slot Cover
c. Hold the VDC600 board by either end and insert it into the expansion slot (Figure 3-3).
If the WGS you are installing has pressure tabs (to help hold the expansion boards), gently
push down on these tabs as you slide the board into the slot.
Ensure that the connector on the VDC600 board is aligned with the expansion slot socket.
Figure 3-3. Inserting a Card into an Expansion Slot on a 6386/25