2. Preparing the Mother Board
_
______________________________________________________________________________________
_
______________________________________________________________________________________
_
______________________________________________________________________________________
Certain configurations of an AUDIX Voice Power system require that you access the mother board to
install additional memory and/or disable the second serial port.
INSTALLING ADDITIONAL MEMORY
This procedure is required for all systems with less than 8Mbytes of RAM currently installed. If you do not
need to install additional memory, skip this section. Your next step will be one of the following:
•
If you are integrating the AUDIX Voice Power system with a System 75/DEFINITY
G1 or G3
Communications System, continue with Disabling the Second Serial Port later in this chapter.
•
There are two parts to this procedure:
•
Adding single in-line memory modules (SIMMs) to the mother board
•
Installing the total onboard RAM jumper
Adding SIMMs to the Mother Board
1. Locate the empty SIMM sockets on the WGS mother board.
NOTE
The location differs for each WGS model; see Figures 2-1 through 2-3 for the SIMM
socket location on individual models. (There are two versions of the 6386/25 mother
board. Compare the mother board in the WGS you are installing to Figures 2-2 and 2-3
to determine which version you have.)
2. If you are installing a 6386/33 WGS, disconnect all cables that cover the air deflector. Remove the air
deflector by gently pulling it outward from the chassis. Remove the cables connected to the hard
drive and floppy drive and fold them out of the way (near the disk controller circuit card) to gain
access to the SIMM sockets.
If you are installing a 6386/25 WGS, skip this step and continue with step 3.
2-1