F E A T U R E S E T U P
Feature Summary (cont’d)
Feature/System Announces
Options
Priority Call Code
Change the Priority Call Code to any three-digit
number from 500–999. Code is preset to 999. Do
not set to same number as Remote Access Code. See
“Priority Calling Code” under ANSWERING SYSTEM
OPERATION for information about using this feature.
Announcement Monitor
Choose ON to hear the announcement when your
system answers a call. Choose OFF to have it silent
on your end. (Your caller will still hear the
announcement.)
NOTE:
Volume must be set to a level you can hear
to use Announcement Monitor.
Number Announce
When this feature is on the system will announce the
caller’s telephone number between the second and
third rings.
NOTE:
When the Number Announce feature is
on and Number of Rings is set for two rings or
Toll Saver 2/4, the unit will answer after three
rings to allow enough time for the system to
announce the caller’s telephone number.
Store Number
When this feature is on, the system announces the
caller’s telephone number when it plays back a
message.
Accept Blocked Calls
Choose ON to have the system accept all calls.
Choose OFF to have the system respond to “blocked”
calls with the pre-recorded announcement, “
We’re
sorry, blocked calls to this number cannot be
accepted,”
and hang up without recording a message.
Call Screening
Set the system to play callers’ messages as they are
recorded (ON) or to remain silent while callers are
recording messages (OFF).
NOTE:
Volume must be set to a level you can hear
to use Call Screening.
Ring Select
Choose from four possible ringer tones. You will hear
“Selected ring is...”
a sample as you change the setting.
NOTE:
For this feature to work, you must subscribe to Caller Identification service
from your telephone service provider. There is a fee for this service, and it may not be
available in all areas.
Review Feature Setup
To review the current feature settings, press and release
S
.
4
(Please see
NOTE
below.)
(Please see
NOTE
below.)
(Please see
NOTE
below.)
