ATAGO 3603, Инструкция по эксплуатации

Страница: 8 / 26

8
3. Unpacking and Installation
(1) Unpacking
①
Unpack the CM-
BASEα and confirm that there is no external damage.
②
Check that the following items are included.
CM-
BASEα(A) Cat.No. 3603

Main unit ..................................................... 1

Power and Recorder output cable ............... 1

O-ring (Silicon) ............................................ 1

O-ring (EPDM) ............................................ 1

Bracket

Instruction manual (this book) ..................... 1

Inspection certificate ................................... 1
CM-
BASEα(D) Cat.No. 3604

Main unit ..................................................... 1

Power and RS-232C cable .......................... 1

O-ring (Silicon) ............................................ 1

O-ring (EPDM) ............................................ 1

Bracket

Instruction manual (this book) ..................... 1

Inspection certificate ................................... 1
(2) Installation

WARNING
◇
Do not supply power (DC24V) until cable connection has been
established
.
①
The CM-
BASEα should be supplied with DC24V (allowable fluctuation is ±10%).
②
The CM-
BASEα should be installed in a location with an ambient temperature of 5 to
40 ˚C.
③
Because the CM-
BASEα incorporates highly precise components, DO NOT install in
locations exposed to direct sunlight or near a heating source, or in an environment
that is dusty or exposed to corrosive gasses.
④
The CM-
BASEα should be installed in a location that is free from vibration. When
installing, take special care to avoid any strong shock to the instrument.
⑤
Do not touch the prism surface with your hand. Finger-prints left on the prism surface
may cause sample to build up on the prism.
In the event of contact with the prism surface, clean carefully with a soft tissue soaked
with ethyl alcohol.
In order to prevent scratches, never clean the prism surface using abrasive materials.