Atag WS90211MX, Инструкция по эксплуатации

Страница: 96 / 112

Cleaning
WARNING!
Important! For all maintenance, first, switch off the mains power to the cooker hood by pulling
the plug out of the socket or by turning off the home's master switch. The hood needs to be
cleaned regularly, both inside as well as outside (at least as often as the grease filter).
Do not use abrasive cleaning products. Do not use alcohol!
If the instructions regarding cleaning the appliance or replacing the filters are not followed, this
can cause a fire. These instructions must be followed! The manufacturer is not liable for damage
to the hood or fire damage resulting from incompetent maintenance or from non-adherence to
the safety instruction above.
Cooker hood
Clean the cooker hood with soapy water and a soft cloth.
Then rinse with clean water. Do not use aggressive cleaning agents such as caustic soda. The cooker
hood finish stays in good condition if it is buffed periodically following the application of wax.
NOTE!
Stainless steel cooker hoods
Do not use scouring pads or other abrasive cleaners on stainless steel cooker hoods. Finish with
a non-abrasive, non-polishing agent and buff the stainless steel in the direction of the grain.
Filter cleaning indicator
The filter indicator will light after 30 operating hours.
• The grease filters should then be cleaned.
• Metal grease filters should be cleaned once a month (or when indicated by the filter cleaning
indicator) using a neutral cleaning agent, either by hand or in the dishwasher on a short,
low-temperature program.
• Place the grease filters with the openings facing downwards in the dishwasher so the water can
drain out of the filter. Aluminium grease filters become dull as a result of dishwasher cleaning
agents. This is normal and does not affect the working. Allow the filters to drain well before
replacing.
• Reset the memory by long touching the – (minus) key until the filter indicator goes off.
Removing grease filter
1. Switch off the motor and lighting.
2. Open the filter’s access hatch.
3. Removing the filter out of the hood.
12
Maintenance