Water hardness
Water hardness ad-
justment
German degrees
(°dH)
French degrees
(TH°)
mmol/l
Clarke de-
grees
manually
elec-
troni-
cally
< 4
< 7
< 0,7
< 5
1
2)
1
2)
1) Factory position.
2) Do not use salt at this level.
You must adjust the water softener man-
ually and electronically.
Manual adjustment
Turn the water hardness dial to the position
1 or 2 (refer to the table).
Electronic adjustment
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C
until the indicator lights of function but-
tons A, B and C start to flash.
4. Release function buttons B and C.
5. Press function button A.
– The indicator lights for function buttons
B and C go off.
– The indicator light for function button A
continues to flash.
– The display shows the current adjust-
ment.
– The intermittent audible signals tell the
current adjustment.
Example: the display shows
/ 5 in-
termittent audible signals = level 5.
6. Press the function button A again and
again until the display shows the neces-
sary adjustment.
7. Press the on/off button to keep the op-
eration.
If the water softener is set electronically
to the level 1, the salt indicator light stays
off.
Use of dishwasher salt
How to fill the salt container:
1. Turn the cap counterclockwise and open
the salt container.
2. Fill the salt container with 1 litre of water
(only for the first time you fill with salt).
3. Use the funnel to fill the salt container with
salt.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap clockwise to close the salt
container.
It is correct that water comes out from
the salt container when you fill it with salt.
28
