Atag VA8018WTC, Руководство по эксплуатации

Страница: 33 / 112

3. Basic settings
Open the door and press the main power switch.
" This is a first time set up. " is shown on the display. It is important
that you choose the right settings to ensure good dishwashing results.
Confirm setting
Select setting
Main power switch
Settings
Language 1.
Select the language to be shown on the display.
Rinse aid 0/1/2/3/4/5/TAB 3.
Drying is faster and a better result is achieved if you use rinse aid.
You will also achieve a better dishwashing result with clear and
spotless dishes.
Select rinse aid dosage. The rinse aid dispenser can be adjusted
between 0 (Off) and 5 (High dosage).
When using an all-in-one detergent that contains rinse aid, you can
activate the setting TAB. Read more about all-in-one detergent in the
chapter Using the dishwasher.
Pre-selected at factory: 5
Top up rinse aid
Press to open
1. Open the rinse aid compartment lid.
2. Carefully top up with rinse aid to the level marked max .
3. Wipe up any splashes of rinse aid around the compartment.
4. Close the lid firmly.
Water hardness 0/1/2/3/4/5/6/7/8/9 4.
Adjusting the water softener. Select a setting depending on the
hardness of the water supply. It is important that this setting is correct!
Do not forget to put salt in the salt compartment after you have set
the water softener to 1 - 9.
For a water supply with a hardness under 6°dH (9°fH), select 0. The
water softener is deactivated and no salt is needed.
Pre-selected at factory: 4
Top up salt
Salt compartment lid
1. Unscrew the salt compartment lid.
2. Place the funnel supplied with the dishwasher in the salt
compartment top-up hole. First, pour in about 1 l of water.
3. Then add salt, a maximum of 1.0 kg, until the compartment is full.
Use large grain salt or special dishwasher salt.
4. Wipe up any excess salt so that the lid can be screwed on firmly.
In order to avoid rust stains a dishwashing programme must be started
immediately after adding salt.
5