Installation and connection information
DISHWASHER CAvITY MEASUREMENTS
H =
Min
823 mm
50-105 mm
38 mm
W = 600 mm
M
in 565mm
WATER CONNECTION
• The machine can be connected to a cold or
hot water supply (maximum 85°C). However,
°C). However,
C). However,
we recommend connection to a cold water
supply.
• The inlet pipe has a connector with either a
3/4” internal thread.
DISHWASHER MEASUREMENTS
ELECTRICAL CONNECTION
• 220230VAC mains voltage, minimum 15A
DRAINAGE
• The supplied coneshaped connection pipe
fits a drainage connection with an internal
diameter of 13, 16, 18 and 22 mm.
• Use a hose clamp if connecting to a fixed drain
(sink).
The connector is ready to cut to the desired
drain connection size. Only a clamp is required.
TOOLS
1) Flathead screwdriver
2) Openended spanner 16 mm
3) Tape measure
4) Spirit level
CABLE/HOSE LENGTHS
Drainage hose: 1930 mm
Supply hose: 1670 mm
Power cable: 1770 mm
Make sure the edges of the
cable hole are even so as not
to damage the drainage and
supply hoses and the electric
cable.
Cable hole
Min 823
Min 560
600
135-18
5
50
50-105
596
820-870
520
560
With nut and sliding protection mounted
Recommended measurements
**
*
*
**
*
*
100-
150
