Atag KA2512WD, Инструкция по эксплуатации

Страница: 12 / 44

EN 12
• Spacers are fitted on the corners of the
doors. Remove them.
• The appliance must stand level or tilted
slightly to the back, stable on a solid base.
At the front, the appliance is fitted with two
adjustable legs that can be used to level
the appliance. At the rear side, casters
allow for easier installation of the appliance
(only with some models).
• There should be a clearance of at least
5 cm between the appliance and any
cupboard installed above it, in order to
allow adequate cooling of the condenser
unit.
• The appliance is supplied with two spacers
which should be installed on the lower part
of the housing to prevent from pushing the
appliance too close to the wall. Appliance
may also be installed without the spacers;
however, this may increase power
consumption.
• Do not expose the appliance to direct
sunlight and do not place it near any
source of heat. If this cannot be avoided,
install an insulation panel.
max
30 mm
>
90°
INTRODUCTION
Installing the appliance
Appliance installation should be carried out by at least two persons to avoid any physical injury
or damage to the appliance.