Atag CM4511AC, Руководство пользователя

Страница: 16 / 42

EN 16
USE
3. Press the ‘Hot water’ touch key (8). Hot water is dispensed; the
display shows “HOT WATER”. Once the programmed amount of
hot water is dispensed, dispensing stops automatically. For a few
seconds the display shows “PREPARATION RUNNING PLEASE
WAIT”. After that the appliance is ready to make coffee again and
the last selected coffee setting appears on the display.
Changing the quantity of hot water
The machine is set by default to automatically delivery 150 ml of hot
water. To change these quantities, proceed as follows:
1. Place a container underneath the water spout.
2. Keep the ‘Hot water’ touch key (8) pressed until the message
“PROGRAM QUANTITY” is displayed and hot water delivery begins.
3. As soon as the hot water in the cup reaches the required level, press
the same icon again. The quantity set has now been programmed.
Making cappuccino
This feature allows you to make cappuccino. To do this, use the special
milk container. Rinse the milk container under the tap when you use it
for the first time.
1. Select the taste of the coffee you want to use to make the
cappuccino by pressing the ‘Coffee strength’ touch key (2).
2. Remove the lid of the milk container.
3. Fill the container with about 100 grams of milk for each cappuccino
to be prepared.
▷ Never exceed the MAX level (corresponding to about 750 ml)
marked on the container.
▷ You should ideally use skimmed or semi skimmed milk at
refrigerator temperature (about 5°C).
▷ Make sure the intake tube is correctly inserted in the rubber
washer.
4. Then replace the milk container lid.
▷ The quantity of froth can be adjusted by moving the regulator to
‘CAPPUCCINO’ or ‘CAFFE LATTE’:
▷ CAFFE LATTE for a denser froth.
▷ CAPPUCCINO for a less dense froth.
8
2 2
1
no froth (hot milk)
“Less dense” froth
Froth regulator
“Denser” froth