©2021 A+T 5
APPENDIX C
Mounting the 3020 display
DO NOT USE Acetone or any alcohol based solvent agents for cleaning.
These may damage the plastic materials on the display.
Recommendations:
a) A 1mm clearance between the Analogue and the bulkhead cutout
b) Use the supplied gasket to mount on a clean, flat surface.
c) Should you require additional waterproofing, or are mounting on a
curved surface, use a bead of proprietry
NON-ADHESIVE
sealant
instead of the supplied gasket and fasten using small spacers to achieve
an even gasket without squeezing all the sealant out of the gap.
a. Once the sealant has cured, remove spacers and gently tighten
the fastenings to take up on the now formed gasket.
b. Clean away any surplus sealant.
d)
DO NOT OVERTIGHTEN THE FASTENINGS
. Ovetightening could lead
to distortion of the display body and consequential loss of
watertight/airtight integrity or break the glass or the mounting lugs. None
of these ocurrences are covered by warranty.