ASV PT-70, Руководство по эксплуатации и обслуживанию

Страница: 10 / 71

SAFETY
Fire Prevention
10
Fire Prevention
Rubber Track Loaders have
components that operate at high
temperatures. Steps must be
taken to make sure that flamma-
ble items are kept clear of these
components during operation.
Failure to do so may result in a
fire.
The main heat sources in the
vehicle are the engine and the
exhaust system. The electrical
system could also be a source
of heat/sparks if damaged or
poorly maintained.
In some work environments,
flammable items such as leaves,
straw and brush cutting debris
may come in contact with these
sources. It is very important that
these flammable items be
removed often from areas close
to hot components. If debris is
allowed to accumulate, a fire
may result posing a risk to the
operator and the machine. A fire
can cause machine damage,
severe injury or even death.
Listed are a set of precautionary
tasks that should be performed
daily or more often if necessary.
Repair or replace worn or dam-
aged components as needed to
ensure safe machine operation.
Precautionary Tasks:
• With the engine off and cool,
remove any debris present in
the engine compartment and
chassis area (under cab).
Remove the belly pans and
pressure wash these areas
to clean them properly.
• Check the battery, fuse box,
electrical wiring and connec-
tion points for damage or
looseness.
• Check fuel lines for leaks or
damage. Never allow open
flame near fuel or fuel system
components.
• Check hydraulic lines, hoses
and fittings for damage or
leaking fluid. Never use bare
hands to check for leaks.
Pressurized fluid can pene-
trate skin and cause injury or
even death.
• Do not use ether or any other
aerosol type starting aid to
start the engine.
• Always stop the engine and
allow the machine to cool
prior to adding fuel.
• Do not smoke or allow open
flame near the machine while
refueling.
WARNING