Installation manual
English
Selecting the voltage
The system’s power supply unit has a 115 V�230 V volta�e
selector switch located beside the power connector. Use
this switch to select the appropriate system input volta�e
accordin� to the volta�e supply in your area.
If the volta�e supply in your area is 100-127 V�� set the switch
to 115 V.
If the volta�e supply in your area is 200-240 V�� set the switch
to 230 V.
Removing the side cover and front panel assembly
1.
Remove the cover screws on the rear panel.
2.
Pull the side cover toward the rear panel until its hooks disen�a�e from the chassis tab
holes. Set the side cover aside.
3.
Locate the front panel assembly hooks�� then lift them until they disen�a�e from the
chassis.
4.
Swin� the front panel assembly to the ri�ht�� until the hin�e-like tabs on the ri�ht side of
the assembly are exposed.
5.
Remove the front panel assembly�� then set aside.
Chassis tab holes
NOTE:
Refer to the system User Guide for the exact location of the volta�e selector.
Installing a CPU
CAUTION!
To prevent dama�e to the
socket pins�� do not remove the PnP cap
unless you are installin� a CPU.
Installing an Intel CPU
1.
Locate the CPU socket on the motherboard.
2.
Press the load lever with your thumb (2A)��
then move it to the left (2B) until it is released
from the retention tab.
Load lever
Retention tab
2A
2B
1
2
1
2
3
3
3
4
4
4
4
V7-P5G43 QSG.indb 4
��1�0� 4:5�:46 PM
