Asus R680EI-IM-A, Руководство пользователя

Страница: 44 / 58

3-10
R680EI-IM-A
Stop Bits
Stop bits indicate the end of a serial data packet. The standard setting is 1
stop bit. Communication with slow devices may require more than 1 stop bit.
Configuration options: [1] [2]
Flow Control
Flow control can prevent data loss from buffer overflow. When sending
data, if the receiving buffers are full, a “stop” signal can be sent to stop the
data flow. Once the buffers are empty, a “start” signal can be sent to re-start
the flow. Hardware flow control uses two wires to send start/stop signals.
Configuration options: [None] [Hardware RTS/CTS]
VT-UTF8 Combo Key Support
Allows you to enable or disable VT-UTF8 Combination Key Support for ANSI/
VT100 terminals. Configuration options: [Disabled] [Enabled]
Recorder Mode
With this mode enabled only text will be sent. This is to capture Terminal
data. Configuration options: [Disabled] [Enabled]
Resolution 100x31
Allows you to enable or disable extended terminal resolution.
Configuration options: [Disabled] [Enabled]
Putty KeyPad
Allows you to select FunctionKey and KeyPad on Putty.
Configuration options: [VT100] [LINUX] [XTERMR6] [SCO] [ESCN] [VT400]
COM6(Pci Bus0
,
Dev0,Func0) (Disabled)
The following items can be configured only when AMT is provisioned.
Console Redirection Settings
Redirection COM Port
Allows you to select a COM port to display redirection of Legacy OS and
Legacy OPROM Messages.
Configuration options: [COM1] [COM2] [COM3] [COM4] [COM5] [COM6(Pci
Bus0,Dev0,Func0) (Disabled)]
Resolution
This allows you to set the number of rows and columns supported on the
Legacy OS. Configuration options: [80x24] [80x25]
Redirect After POST
Configuration options: [Always Enable] [BootLoader]
[Always Enable] Legacy Console Redirection is enabled for Legacy OS.
[BootLoader] Legacy Console Redirection is disabled before booting
to Legacy OS.