ASUS PRIME J4005I-C
1-3
DDR4 DIMM slots
Install 1 GB, 2 GB, 4 GB, and 8 GB unbuffered non-ECC DDR4 DIMMs into these
DIMM sockets.
For more details, refer to
System memory
.
System panel connector (10-1 pin F_PANEL)
This connector supports several chassis-mounted functions.
Speaker connector (4-pin SPEAKER)
This 4-pin connector is for the chassis-mounted system warning speaker. The
speaker allows you to hear system beeps and warnings.
Display panel VCC power selector (VCC_PWR_SEL)
1
3V
(Default)
2
5V
3
12V
VCC_PWR_SEL
Flat panel display brightness connector (8-pin LCD_BLKT_PANEL)
This connector is for the LCD panel backlight and brightness controls. It enables
the LCD panel backlight, provides backlight control signals, and provides brightness
control signals for the brightness button on the front panel.
Intel
®
Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~2)
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA
6.0 Gb/s signal cables.
LVDS connector (40-pin LVDS)
This connector is for an LCD monitor that supports Low-voltage Differential
Signaling (LVDS) interface.
Panel switch (2-pin PANEL_SW)
This 2-pin header is for connecting a monitor switch that can turn off the LCD panel
display backlight.
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this connector.
The chassis intrusion sensor or switch sends a high-level signal to this connector
when a chassis component is removed or replaced. The signal is then generated
as a chassis intrusion event.
The chassis intrusion detection feature is disabled by default. To enable it, set the
Chassis Intrude Detect Support
item in the BIOS to [
On
].
Pins
Setting
1 (Default)
3V
2
5V
3
12V
