ASUS PCI-SIU2 User’s Manual
29
5
Overview
The ASUS ASPI driver will support extended SCSI command functions for
MS-DOS 3.30 or later. The on-board BIOS initialized during the power up
boot routine only supports MS-DOS hard disk operation. If peripherals other
than disks are used, such as CD-ROM or MO, the ASUS ASPI driver will need
to be installed in addition to ASUS CD-ROM and MO drivers.
Installation
The installation procedure guides you through the installation of the ASUS
DOS ASPI. The installation procedure described here requires some experi-
ence in MS-DOS setup and administration. The device driver is transferred
from the PCI-SIU2 DRIVER DISK to the hard drive where it is automatically
initialized during the system boot routine.
The PCI-SIU2 DRIVER DISK contains one installation program that per-
form the same task.
Installing the ASPI drivers to an existing MS-DOS
system
The ASPI driver is found on the PCI-SIU2 DRIVER DISK . It is important
that the SCSI bus hardware, and operating system are installed correctly before
proceeding further. If you need help installing the MS-DOS operating system,
please refer to the MS-DOS manual before proceeding.
1.
Turn on host system and boot into MS-DOS.
2.
Insert the PCI-SIU2 DRIVER DISK into your floppy drive.
3.
At the MS-DOS prompt, change to your active floppy drive (e.g.,
type A: <ENTER>).
4.
Type DOSSETUP <ENTER> (A series of screens will guide you
through the installation of the ASPI device drivers).
5. MS-DOS Driver Installation
Содержание PCI-SIU2
