A S U S M 2 N P V - M X
A S U S M 2 N P V - M X
A S U S M 2 N P V - M X
A S U S M 2 N P V - M X
A S U S M 2 N P V - M X
1 - 2 7
1 - 2 7
1 - 2 7
1 - 2 7
1 - 2 7
3 .
3 .
3 .
3 .
3 .
I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E ; 4 0 - 1 p i n S E C _ I D E )
I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E ; 4 0 - 1 p i n S E C _ I D E )
I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E ; 4 0 - 1 p i n S E C _ I D E )
I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E ; 4 0 - 1 p i n S E C _ I D E )
I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E ; 4 0 - 1 p i n S E C _ I D E )
The onboard IDE connectors are for Ultra DMA 133/100/66 signal
cable(s). There are three connectors on each Ultra DMA 133/100/66
signal cable: blue, black, and gray. Connect the blue connector to the
motherboard's IDE connector, then select one of the following modes
to configure your device(s).
M2NPV-MX
®
M2NPV-MX IDE connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_IDE
PIN 1
SEC_IDE
•
Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE
devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
Black or gray
D r i v e j u m p e r
D r i v e j u m p e r
D r i v e j u m p e r
D r i v e j u m p e r
D r i v e j u m p e r
M o d e
M o d e
M o d e
M o d e
M o d e
C a b l e
C a b l e
C a b l e
C a b l e
C a b l e
s e t t i n g
s e t t i n g
s e t t i n g
s e t t i n g
s e t t i n g
o f d e v i c e ( s )
o f d e v i c e ( s )
o f d e v i c e ( s )
o f d e v i c e ( s )
o f d e v i c e ( s )
c o n n e c t o r
c o n n e c t o r
c o n n e c t o r
c o n n e c t o r
c o n n e c t o r
Single device
Cable-Select or Master
-
Black
Two devices
Cable-Select
Master
Black
Slave
Gray
Master
Master
Slave
Slave
