A S U S A P 2 4 0 0 R - E 2
A S U S A P 2 4 0 0 R - E 2
A S U S A P 2 4 0 0 R - E 2
A S U S A P 2 4 0 0 R - E 2
A S U S A P 2 4 0 0 R - E 2
2 - 3 3
2 - 3 3
2 - 3 3
2 - 3 3
2 - 3 3
2.7
Removable components
You may need to remove previously installed system components when
installing or removing system devices, or when you need to replace
defective components. This section tells how to remove the following
components:
1.
Hot-swap mid-fans
4.
Optical drive/floppy drive
2.
Rear fans
5.
Front panel LED/switch board
3.
Power supply modules 6.
SCSI backplanes
2.7.1
2.7.1
2.7.1
2.7.1
2.7.1
Hot-swap mid-fans (80mm)
Hot-swap mid-fans (80mm)
Hot-swap mid-fans (80mm)
Hot-swap mid-fans (80mm)
Hot-swap mid-fans (80mm)
The fan LED lights up green in normal operation. If the LED color turns
orange, the fan is faulty and should be replaced.
To remove an 80mm hot-swap fan:
1.
Stand in front of the system and
open the top cover.
2.
Use the thumb and index finger of
your right hand to flip up the right
handle, and the thumb and index
finger of your left hand to flip up the
left handle of the fan that you want
to remove.
Avoid touching the fan blades while
removing the fan. Spinning fan
blades may cause injury!
3.
Firmly hold the handles and pull up
the fan until it is disengaged from its
connector.
N o t e o n t h e p o w e r s u p p l y m i d - f a n
N o t e o n t h e p o w e r s u p p l y m i d - f a n
N o t e o n t h e p o w e r s u p p l y m i d - f a n
N o t e o n t h e p o w e r s u p p l y m i d - f a n
N o t e o n t h e p o w e r s u p p l y m i d - f a n
When you re-install the mid-fan for the
power supply module(s) make sure that
the arrow points to the direction of the
rear panel. Installing the fan otherwise will
cause CPU overheating.
Содержание AP2400R-E2
Страница 10: ...x x x x x ...
