PICO-KBU4-SEMI Quick Installation Guide
Install Guide Steps
Step 1:
Remove the bottom panel of the system case by sliding the panel towards the I/O (rear) side of the system.
Step 2:
Remove the two screws securing the 2.5” drive bracket. Remove the bracket and set aside.
Using a tool, remove the USB 2.0 port punchouts if you haven’t already done so.
Step 4:
Remove the cover for the thermal padding attached to the heat sink (top of system).
Step 3:
On the processor side of the PICO-WHU4 board, install the memory RAM module. Insert at an angle (~30
°
)
and then gently press down until it is secured in place.
