11
STOP
+
When the engine is running remotely, you can turn it off by performing a stop command.
ADVANCED FEATURES
STATUS
When this command is sent, the vehicle checks the status for the engine, the protection zones and
for the locks, then retransmits this information to the remote control. The results show up on the
LCD display through a combination of pictograms and text in the text field.
When the remote control receives a confirmation, it flashes the relevant pictograms and vibrates
twice.
If the vehicle is out of range, the remote control will give a soft chirp after three (3) seconds,
indicating that either the vehicle or the remote could not receive the command.
UTILITY COMMANDS
These commands allow you to control most of the vehicle’s accessories depending on what was
connected during the installation (headlights, defroster, etc.). For more information, check with your
technician.
To activate these functions, simultaneously press the buttons as shown in the following table. (Fill-
up the blanks).
Commands Buttons
Corresponding accessory
Duration
UTILITY 1 *
+
UTILITY 2
+
The accessory associated to each command is activated for the duration set at time of installation.
The delay can be cancelled by repeating the command.
*
Programmable at time of installation: the “trunk” command can activate utility 1.