9
AUTOMATIC LOCK/UNLOCK
This function is :
Active
Inactive
(programmable during installation).
This function locks the doors when ignition key is in “
ON
” position, engine is running and brakes are applied. Doors are
unlocked when key is turned from “
ON
” to “
OFF
” or when Continuous Mode is activated.
If “Unlock“ function is set to unlock only driver's door on the first command, the “Automatic Unlock“ function will unlock
driver's door only. If dome light is connected to system, it is activated when an automatic unlock occurs.
ANTITHEFT (CIRCUIT DISABLER)
(Option 2 only )
Programmable as
Active
or
Inactive
during installation.
Your Remote Starter is equipped with an Antitheft system. This system consists of an output that controls a relay that cuts
the circuit required to operate your vehicle (optional connection).
“PASSIVE ARMING" TYPE ANTITHEFT
This type of Antitheft system arms automatically when ignition key is turned from “
ON
” to “
OFF
” and remains “
OFF
” for
one minute. It can also be armed manually by sending a “Lock” command (unless ignition key is in “
ON
” position).
D
ISARMING
Antitheft system is disarmed for one minute when you send “Unlock” command.
If the ignition key is not turned to “
ON
” position within one minute, system automatically rearms, thus preventing any
intruder from starting your vehicle, even with the key in the ignition switch.
It can be connected so that horn sounds if an intruder tries to start your vehicle when it is in the active state.
“ACTIVE" TYPE ANTITHEFT
This type of Antitheft system arms by sending the “Lock” command (unless ignition key is in “
ON
” position) and disarms by
sending the "Unlock" command.
CODE LEARNING OF ADDITIONAL TRANSMITTER(S)
Four different remote controls can be programmed for a given vehicle. If a fifth remote is added, the first remote is deleted.
Note
: When the first code learning command is sent, all the old codes are cleared out. therefore if you want to add a new
remote, all the old ones must be reprogrammed as well.
One or more remote transmitters can be added. To do this, the programming is accessed as follows:
Open hood
Place key in the ignition and turn to the “RUN” position
Apply the brakes once
You now have 10 seconds to turn the key from “RUN” to the “STOP” position 3 times.
If this sequence is correctly carried out, the control module flashes parking lights (4 flashes). You may then
proceed to the next step.
Press any button on the new remote control. When access code of new remote control is memorized, the
control module will confirm with flashing parking lights (1 flash).
Repeat the above procedures for each remote control that has to be programmed (up to 4 remotes).
Apply the brakes.
New remote(s) is (are) now added to the system.
