background image

 

10

 

GEARSHIFT CHECK APPLICABLE TO AUTOMATIC TRANSMISSION VEHICLES 

If key must be in ignition for gearshift to be moved out of 

P

, your vehicle is safe as long as keys are kept away from children. 

If, on the other hand, gearshift can be put in gear without the key being in the ignition, proceed with this simple check. 

• 

Put gearshift in gear (

D

). 

• 

Remain in the vehicle and be ready to apply brakes. 

• 

Start vehicle with remote starter. 

• 

Repeat these steps with gearshift in every position other than 

Park

 and 

Neutral

If starter reacts within 90 seconds (which would be abnormal), turn main switch to OFF position 

and leave it off until 

situation is rectified

. Contact your service centre. 

• 

With gearshift in 

P

, start vehicle with remote starter. 

• 

Remain in vehicle and 

be ready to apply brakes

• 

Without applying brakes

, move gearshift out of 

P

 
If, without applying brakes, engine does not stop immediately (which would be abnormal), turn main switch to 

OFF

 position 

and leave it off until situation is rectified.

 Contact your service centre. 

GEARSHIFT CHECK APPLICABLE TO MANUAL TRANSMISSION VEHICLES 

Make sure the parking brake is operational, i.e. it has the capability of 

immobilizing

 the vehicle.  

If the parking brake cannot stop the wheels from turning, which is not safe, place the main switch in "

OFF

position until the 

situation is rectified

.  

D

ETECTION OF PARKING BRAKE STATUS

 

1.  Carry out the safety sequence, then remote start the engine to confirm the safety sequence is valid.  

Make sure not to apply the brakes.  

2. 

Release the parking brake.  

The engine must stop immediately upon releasing the parking brake. If the engine does not stop, which is not safe, place the 
main switch in "

OFF

position until the situation is rectified

. Consult your service centre. 

D

ETECTION OF DOOR OPENING

 

Make sure that the opening of 

each 

door (open one by one) will break safety sequence.  

1. 

Carry out the safety sequence, then remote start the engine to confirm the safety sequence is valid. 

2. 

Stop the engine using the remote control. Make sure you do not apply the brakes and that the parking brake 
remains applied until step 4.  

3. 

Open then close 

only one door 

once the engine has stopped.  

4. 

Try to start the engine using the remote control.  

The engine should not be able to be remote started. 
Repeat this test 

for every door 

of the vehicle (

including hatchback 

if applicable).  

If the vehicle is equipped with fold-down rear seat backrests, the trunk has to be considered as a door since it is an opening 
that can give access to the passenger compartment. It 

must 

therefore be included in the safety sequence. 

If the engine starts, which is not safe, place the main switch in "

OFF

position until the situation is rectified.

 Consult your 

service centre.

 

REPLACING OR BOOSTING VEHICLE BATTERY 

If you have to replace or boost your battery for any reason, turn main switch to 

OFF

 position 

and leave it OFF until battery 

is replaced or fully charged.

 

 

R

EVERSING POLARITY WHEN BOOSTING YOUR BATTERY

 

COULD PERMANENTLY DAMAGE YOUR REMOTE STARTER

.

 

Содержание 701U













Отзывы: