AstroJet 3600P? 3800P, Руководство оператора, Страница: 10 / 34

SECTION 2
INSTALLING THE PRINTER
6
Installing the Optional FF14 Friction Feeder
Assembling the Feeder
After unpacking the Feeder, install the two Side Guides as
shown using the four screws supplied
(two on each side ).
Place the Feeder on a flat level surface. The Feeder can be
permanently mounted by removing the four rubber feet,
aligning the Feeder on the Support Stand, then reinstalling
the feet to hold the Feeder in place.
Plugging in the Feeder
Make sure that the Main Power Switches on the Printer and the Feeder are in the OFF position.
1. Connect one end of the power cord to the rear of the Feeder in
the corresponding receptacle.
2. Plug the other end into a 115-220 Volt AC, 50/60 Hz.
grounded outlet.
CAUTION
Do not use an adapter plug or extension cord to
connect the printer to the wall outlet.
Do not use outlets controlled by wall switches.
Do not use an outlet that shares the same circuit with
large electrical machines or appliances.
Connecting the Optional Feeder to the Printer
The Printer/Feeder Communication
Cable must be attached to the Printer and
the Feeder for the two machines to work
together. Remove the Jumper Plug from
the Printer (
if installed ) and attach the
Printer/Feeder Communication Cable
between the two machines as shown in
the photo at the right.
Completing Assembly of the System
Remove the packing blocks from the Printheads and install the Side Guides on the Feeder if not already done.
Printer Connection
Feeder Connection