14
Operating Manual U 124 16-programme IP / FM converter
14
6.3 U 100 settings
Under “U 100 Rack Settings” an address can be allocated to the relevant base device. The num-
ber of the currently selected slot is displayed below it:
Figure 7: Rack settings
If the U 124 is managed using the U 100-C controller and there are several U 100 base devices in
use, then each base device must have a different address. The slot address is determined using
the backplane coding (see chapter 2.8.1).
6.4 Saving and loading a configuration / Default and reboot
The current configuration of the U 124 is always written to the device using the “Submit” buttons,
and is therefore activated immediately. If you want to save the current status, you press the “Save
2nd” button. This current status is then saved on the SD card in the U 124. You can call up this
status again using the “Load 2nd” button. Saving the configuration on the local computer or FTP
server is explained in the “Update” chapter.
Figure 8: Saving and loading / default and reboot
The “Default” button is used to restore the factory settings.
Note:
With the factory settings, all the settings apart from the user and network settings of the data and
management ports are reset to the state on delivery!
The “Reboot” button restarts the U 124 with the last settings that were entered.
