3 2-11-93 TI648-93-0
Figure #5
2. If calibration of the hand pressure is required,
locate the adjustment screw in the Movable Die Nest
by closing the tool. Using a flat blade screwdriver,
rotate the screw to the right to decrease the pressure,
to the left to increase the hand pressure. See figure #
5
3. When hand pressure calibration is achieved,
lock screw in place using an appropriate NON-
PERMANENT sealant.
g. Tool Gaging
1. Astro Tool Corp. manufactures flat GO-NO GO
pin assemblies for many of the dies used by the
612648 crimp tool. Contact the factory for your
specific requirements.
GO Pin Inserted
Into Cavity
Figure #6
2. With a die set properly installed, cycle the tool
into the fully closed position. Insert the appropriate
GO sized flat pin into the hex cavity. It shall freely
enter the hex cavity. See figure # 6. Remove the GO
pin and attempt insert the NO-GO pin into the hex
cavity. It should not enter the cavity.
DO NOT CRIMP GAGE, TOOL DAMAGE
WILL RESULT.
ASTRO TOOL CORP. MANUFACTURERS OF INSTALLING, REMOVAL AND CRIMP TOOLS
21615 S.W. T-V HWY.
•
BEAVERTON OREGON 97003
•
503-642-9853
•
FAX 503-591-7766
CONNECTOR ASSEMBLY TOOLING
