Page 2
Step 3
Install Inkjet Cartridges
2650P
holds up to 6 Inkjet Cartridges.
2800P
holds up to 8 Inket Cartridges.
1.
Remove inkjet
cartridge from
packaging.
DO NOT
touch
copper contacts,
metal plate, or gold
printhead. Remove
protective tape from
printhead.
2.
Open latch levers
on inkjet cartridge
holders.
3.
With
cartridge’s
printhead pointing
down, slide
cartridge into
holder, push down
and toward contacts
in holder.
4.
Make sure cartridge
is seated in holder.
Close latch lever to
secure cartridge in
holder.
DO NOT force
lever into place.
5.
Repeat
Steps 1-4
for remaining
cartridges.
Ink in cartridge may be harmful if
swallowed. Keep new and used
cartridges out of reach of
children. Discard empty
cartridges immediately.
Step 4
Setting Up Feed
1. Release Separator Locking Levers (
located on
operator’s side of Feeder
), raise Separators an
lock in position. Move Side Guides to outermost
open position. Place one piece of media in
center of Feed Table.
2.
Four Separators on Feeder.
Use two Center
Separators for narrow media and all four
Separators for wide media. Place media under
Separators and lower Separators onto media.
3. Rotate Locking Lever up to lock Separators
in place.
4. Loosen knobs on Side Guides. Adjust Side
Guides to within
1/32” of media. Tighten knobs.
5. Adjust Rear Guide so media is raised
approximately
1/2” and rests on curve of Rear
Guide. When running
10” or longer or heavy
media Rear Guide may have to be set so it just
touches back of media.
