3.2 Connect the motors with standard cables to CS as shown in Fig. 6a
Fig. 6a
3.3 Install the driver virtual com-port from a CD software
After you install the equipment in system will be new device - Silicon Labs CP210x
USB to UART Bridge (COMx).
3.4 Install a platform ASCOM Platform 6.x. (http://www.ascom-standards.org).
3.5 Install EQMOD Ascom driver located on the CD software.
3.6 Connect the DB9-USB cable to your computer's USB port
3.7 After turning on the power, you will hear a beep that shows the readiness of the CS
to control from the PC.
3.8 Read the settings of the control unit using the EQStar setting application, which is
located on the CD with the software. If they do not match the required settings for the
mount, change and save the correct settings.
