Astria.US.com
126885-01B
16
8. Slightly push in and turn control knob counterclockwise
to
the ON position.
CAUTION: Do not try to adjust heating levels by
using the equipment shutoff valve.
9. To turn off burner and leave pilot lit: Turn control knob clockwise
to the PILOT position. If using optional hand-held remote,
set remote switch to the OFF position to prevent draining battery.
TO TURN OFF GAS
TO APPLIANCE
1. Turn control knob clockwise
to the OFF position.
2. If Using Optional Hand-Held Remote: Set remote switch to the
OFF position to prevent draining battery.
3. Close equipment shutoff valve (see Figure 16, page 13)
WARNING: Make sure remote sensor selector switch
is in the OFF position when you are away from home for
long periods of time.
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 5 under Lighting Instructions, page 15.
2. Depress control knob and light pilot with match.
3. Keep control knob pressed in for 30 seconds after lighting pilot.
After 30 seconds, release control knob. Now follow step 8 under
Lighting Instructions, column 1.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note:
All remote control accessories must be purchased separately
(see Accessories, page 23). Follow instructions included with the
remote control.
Note:
Refer to installation instructions included with optional remote
control for remote operation.
NOTICE: You must light the pilot before using the
hand-held remote control unit. See Lighting Instruc-
tions on page 15.
After lighting, let pilot flame burn for about one minute. Turn control
knob to ON position. Slide the remote selector switch to the REMOTE
position (see Figure 26).
Note:
The burner may light if hand-held remote was on when the
remote selector switch was last turned off. You can now turn the
burner on and off with the hand-held remote control unit.
IMPORTANT:
Do not leave the selector switch in the REMOTE or ON
position when the pilot is not lit. This will drain the battery.
OPERATION
Continued
Figure 26 - Setting the Selector Switch and Control Knob for
Hand-Held Remote Operation
Control
Knob
Selector Switch in
REMOTE Position
(Optional Hand-Held
Remote Control)
Electronic
Ignitor
GWMT1 WALL MOUNTED
THERMOSTAT (OPTIONAL)
Make sure the heater switch is on REMOTE and set the temperature
adjustment on wall thermostat to the desired setting. The thermo-
stat has been electronically calibrated at the factory and requires no
adjustment or leveling.
Upon installation, the thermostat must be allowed to stabilize at room
temperature for a minimum of 30 minutes for proper operation. See
installation instructions on page 13 of this manual.
GWMS2 WALL MOUNTED
SWITCH (OPTIONAL)
Make sure the heater switch is on REMOTE. This wall switch works
just like the conventional light switch. Flip the switch up for on and
down for off.
Note:
Make sure that this switch is not in a position to be mistaken
for a light switch. This may result in the fireplace being inadvertently
turned on without the proper precautions being taken. See installation
instructions on page 14 of this manual.
