Astria.US.com
126823-01C
15
Figure 19 - Touch Pad Control Cable
Figure 20 - Connecting end of Touch Pad
Cable
Touch Pad Wire
Harness
Touch Pad Control
PRESSURE TESTING HEATER GAS
CONNECTIONS
1. Open equipment shutoff valve
(see Figure
14, Page 14).
2. Open main gas valve located on or near
gas meter for natural gas or open propane/
LP supply tank valve.
3. Make sure control knob of heater is in the
OFF position.
4. Check all joints from gas meter to equipment
shutoff valve for natural gas or propane/LP
supply to equipment shutoff valve for pro-
pane/LP
(see Figure 15, Page 14 or Figure
16).
Apply noncorrosive leak detection
fl
uid
to all joints. Bubbles forming show a leak.
5. Correct all leaks at once.
6. Light heater
(see Operation, Page 28).
Check all other internal joints for leaks.
7. Turn off heater
(see To Turn Off Gas to Ap-
pliance, Page 28.
Gas Meter
Figure 16 - Checking Gas Joints (Natural
Gas Only)
Control Valve
Location
Equipment Shutoff Valve
INSTALLATION
Continued
POWER SUPPLY AND BATTERY
INSTALLATION
It is helpful to have a
fl
ashlight so you can
see the connections as described below. Lo-
cate the battery power supply. It is the black
box with the red and black wires. Locate the
control module
(see Figure 17)
. Connect the
battery power supply to the control module
by plugging the battery power supply to the
mating receptacle on the control module. The
receptacle is located on the side of the black
control module next to the word “SUPPLY”
which is molded in the control module’s black
housing
(see Figure 17)
. Be certain to push
the plug fully into the receptacle. Install bat-
teries in the battery power supply and hand
held remote control.
TOUCH PAD INSTALLATION
Locate the touch pad wire harness and the
touch pad control
(see Figure 18).
They are
shipped from the factory in the clear plastic
bag with your owner’s manual. Connect the
black plastic connectors together as shown
in
Figure 19
. Connect the remaining end
with the white plastic connector to the control
module in the socket marked TOUCH LED
(see Figure 20).
NOTE: The touch pad includes a red LED
display light. If the LED remains on, the black
plug is connected upside down. You must
unplug the touch pad control from the touch
pad wire harness, turn over, and reconnect.
Figure 17 - Control Module
S1 Button
Connect Battery Plug Here
Figure 18 - Touch Pad Wire Harness and
Touch Pad Control
