Astria.us.com
126733-01H
20
Replacing Glass Door
1. Position door frame in front of firebox opening with bottom of
door tilted away from firebox
(see
Figure 27, Page 19
).
2. Hook top flange of door frame over top of firebox frame.
3. Secure 2 bottom door latches.
Reinstall the included barrier (J7450, 36" or J7456, 42")
WARNING: Reinstall any barrier removed before
operating the fireplace. The barrier is designed to
reduce the risk of burns from hot glass. Do not operate
the fireplace without the barrier installed.
NOTE:
All models must have a barrier installed prior to operation.
1. Hold the barrier in front of the glass door and slide it up into the
channel underneath the upper front face
(see
Figure 28
).
2. Slide the barrier bottom down into the slots below at the glass
door level, securing it in place
(see
Figure 28
).
Loose
Log #3
Loose Log #2
Loose Log #1
Underneath
Log #2
Glowing Embers
Loose
Log #1
Loose Log #2
Loose Log #3
Figure 29 - Installing Loose Logs
Figure 28 - Installing Barrier
Figure 29a - Installing Loose Log #1
Figure 29b - Installing Loose Logs #2 and #3
FIREPLACE INSTALLATION
Continued
Channel
Barrier
Frame
Slot
3. Place volcanic stone around base of burner. Make sure burner
ports are not covered
(see
Figure 30, Page 21
).
4. Place ember flakes around front and sides of burner and on burner
ports
(see
Figure 31, Page 21
).
This will create the glowing ember
appearance as the flame touches the ember flakes. Do not block
burner ports or pilot ports by overlapping ember flakes in one area.
It is not necessary to use all ember material provided.
5. Place scrap log pieces randomly behind grate as shown in Figure
32 on volcanic stone and around (but not on) burner ports.
6. Place grate in front of logs as shown in
Figure 32, Page 21
. Be
sure grate is balanced so it does not fall or lean onto logs. Grate
does not attach to hearth assembly.
Discontinue use of the appliance immediately if doors
are damaged and contact a qualified installer for repair.
Only doors certified with the appliance shall be used.
VOLCANIC STONE, DECORATIVE GRATE, EMBER FLAKES AND
SCRAP LOG INSTALLATION
Volcanic stone, ember flakes and scrap log pieces are included with
your fireplace. Install these items while glass doors are open and/or
removed.
1. Follow instructions from Removing/Replacing Glass Door,
Page
19
, to move glass out of the way of this installation.
2.
For 36" models only:
Install 3 loose logs by placing log #1, log
#2 and log #3 onto one piece log as shown in
Figures 29, 29a
and 29b
.
f i r e - p a r t s . c o m
