44
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Operation
900301-01 04/2017
Innovative Hearth Products
Marin™ See-Through B-Vent Gas Fireplaces
MAINTENANCE TASK
ACCOMPLISHING PERSON
PROCEDURE
Inspecting/Cleaning Burner, Logs
and Controls
Qualifi ed Service Technician
Inspect valve and ensure it is properly operating. Check piping
for leaks. Vacuum the control compartment, fi replace logs and
burner area.
Check Flame Patterns and Flame Height
Qualifi ed Service Technician
Refer to
Figure 25
on
Page 22
and verify the fl ame pattern
and height displayed by the appliance conforms to the picture.
Flames must not impinge on the logs. Ensure fl ames are steady
(not lifting or fl oating).
Inspecting/Cleaning Pilot and Burner
Qualifi ed Service Technician
Refer to
Figure 45
on
Page 40
. Remove any surface build-up
on pilot and burner assembly. Wipe the pilot nozzles, igniter/
fl ame rod and hood. Ensure the pilot fl ame engulfs the fl ame
sensor as shown.
Checking Vent System
Qualifi ed Service Technician
Inspect the vent system at the top and at the base (within the
fi rebox) for signs of blockage or obstruction. Look for any signs
of dislocation or deterioration of the vent components.
NOTE
: Excessive condensation can cause corrosion of caps,
pipe & fi ttings (excessive condensation can be caused by long
lateral runs, too many elbows and/or exterior portions of the
system being exposed to cold weather). Also inspect wall straps
or plumbers's tape to ensure it is secure and in place.
Appliance Checkout
Qualifi ed Service Technician
Perform the appropriate appliance checkout procedure detailed
in this manual.
Replacing Glowing Ember (rockwool)
Materials
Homeowner/Qualifi ed Service
Technician
Remove old ember materials (rockwool) and vacuum the ember
placement area. Place new embers as described in this document.
Periodically
(After the Burning Season)
MAINTENANCE TASK
ACCOMPLISHING PERSON
PROCEDURE
Cleaning Firebox Interior
Homeowner
Carefully remove logs, glowing embers (rockwool), volcanic
stone and vermiculite. Vacuum out interior of the fi rebox. Clean
fi rebox walls and log grate. Replace logs, glowing embers and
vermiculite as detailed in this manual.
Check Flame Patterns and Flame Height
Homeowner
Refer to
Figure 25
on
Page 22
and verify the fl ame pattern
and height displayed by the appliance conforms to the picture.
Flames must not impinge on the logs.
Checking Vent System
Homeowner
Inspect the vent system at the top and at the base (within the
fi rebox) for signs of blockage or obstruction. Look for any signs
of dislocation of the vent components.
Cleaning Front Glass Enclosure Panel
Homeowner
Clean as necessary following the directions provided in this
manual.
DO NOT TOUCH OR ATTEMPT TO CLEAN GLASS
WHILE HOT
.
Annually
(Before the onset of the Burning Season)
MAINTENANCE SCHEDULE
