Astria Fireplaces Astria Vega32ZP2, Инструкция по установке и эксплуатации

Страница: 16 / 32

www.Astria.US.com
126694-01B 16
3. Remove metal lock nut from plastic con -
trol shaft by turning lock nut with pliers
counter clockwise. Mount speed control
box by placing plastic control shaft
through hole on lower portion of the left
or right side of secondary face by sliding
control box down through large hole in
firebox bottom and up behind firebox side
(see Figure 17). Secure speed control to
side face with previously removed lock
nut by pushing and turning lock nut clock -
wise with pliers until it is tight against side
face of fireplace (see Figure 17).
CAUTION: Use gloves as
sheet metal parts may be sharp.
4. Place control knob, provided, onto control
shaft (see Figure 17).
5. Check to make sure power cord is com-
pletely clear of blower wheel and there are
no foreign objects in blower wheel. Also,
double check all wire leads and make
sure wire routing is not pinched or in a
precarious position. Correct accordingly.
INSTALLATION
Continued
Model BK Installation
1. Be certain that all wire terminals are
securely attached to terminals on blower
motor and that the screw retaining the
green ground wire is tight (see Figure 15).
2. Place blower against lower rear wall of
firebox outer wrapper with exhaust port di-
rected upward. Depending on your model,
you may have to carefully route the blower
assembly past controls and brackets and
position blower inside back opening. The
blower will be held in position against the
back wall by magnets incorporated onto
blower housing (see Figures 15 and 16).
Figure 16 - Blower Model BK (Side View)
Figure 15 - Blower Model BK
Magnetic Strips
Exhaust
Port
Screw
Green
Ground
Wire
Spade
Terminals
Side View
Firebox Bottom
Air Flow
Direction
Blower
Installed
After
Lower
Panel
Removed
Blower
Location Magnets
Figure 17 -Attaching Speed Control
(Model May Vary From Illustration)
Control
Shaft
Control
Access
Control
Knob
Lock Nut
Secondary
Face
f i r e - p a r t s . c o m