ENGLISH
3
KIVU PUMP
- ASTRALPOOL
IMPORTANT
This manual contains basic information on the safety measures to be adopted during installation and start-up. The fitter
and the user must therefore read the instructions before installation and start-up.
1. GENERAL SAFETY INSTRUCTIONS
These symbols (
) indicate the possibility of danger where the corresponding instructions are not followed.
DANGER. Risk of electrocution.
Failure to abide by these instructions may lead to the risk of electrocution.
DANGER.
Failure to abide by these instructions may lead to the risk of injury or damage.
WARNING.
Failure to abide by these instructions may lead to the risk of damage to the pump or the installation.
2. GENERAL SAFETY REGULATIONS
GENERAL
- The machines indicated in this Manual are especially designed for the pre-filtering and recirculation of water in
swimming pools.
- They are designed to work with clean water at temperatures not exceeding 35ºC. (Fig. 4 T med. Max).
- Install them in line with the specific instructions for each installation.
- Respect current regulations regarding accident prevention.
- All modifications to the pump require prior authorisation from the manufacturer. Original spare parts and accessories
authorised by the manufacturer ensure greater safety. The pump manufacturer is exempt from all liability regarding any
damage caused by unauthorised spare parts or accessories.
- When working on each machine or on the units linked to them, disconnect the unit from the power supply and the start-up
devices, as the electrical parts of the pump are live during operation.
- All assembly and maintenance work must be carried out by qualified and authorised personnel who have carefully read the
installation and service instructions.
- To guarantee safety when operating the machine, you must comply with that set out in the installation and service
instructions.
- In the event of defective operation or faults, contact your supplier or nearest representative.
WARNINGS DURING INSTALLATION AND ASSEMBLY WORK
- Once the pump has been removed from the box, it should be handled by the suction inlet and the engine body, and should
not be held up in just one point.
- When connecting the electrical wiring to the machine motor, check the layout inside the connection box and make sure there
are no pieces of wiring inside after it has been closed and that the earthing conductor is correctly connected. Connect the
motor in line with the wiring diagram attached to the machine.
- Make sure that the electrical wiring connections to the machine terminal box are well mounted and screwed tight to the
connection terminals.
