2
ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be im-
plemented for installation and start-up. Therefore, the installer as well as the user must read the instructions before
beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the WiFi Control System for LumiPlus Projectors RGB, follow the instructions provided
below:
1. DESCRIPTION
Mod LumiPlus WiFi Acces Point (59133)
2. LUMIPLUS MODULATOR
The Modulator has a status indicator LED in the lower part of the set, and IP65 antenna and 4 pushbuttons: COLOR,
SEQUENCE, SPEED and / SLEEP.
The main functions of the Modulator are:
• Switching the projectors on/off.
• Colour selection: 12 fixed colours available.
• Sequence selection: 8 sequences available.
• Sequence speed selection: 8 speeds available per sequence.
2.1 INSTALLATION:
• Install the Modulator protected from corrosi-
ve environments, away from metal boxes and
metal piping or electrical wiring.
• The Modulator is connected to the 110 Vac
mains through two terminals indicated RED
(MAINS). It is connected to the transformer
primary (110 Vac) through the terminals indi-
cated TRF (see attached diagram).
• Both the transformer/s and the modulator/s
must be of sufficient size to supply the VA
corresponding to the projectors installed. The
Modulator can withstand up to 440VA. For
each projector, its power and the number of
units that can be connected to a modulator are
specified in the respective manual.
2.2 OPERATION:
Switching on the projectors
The projectors are switched on by pressing any key. If the / SLEEP key is pressed, the projectors are switched on with
the last mode before they were switched off: fixed colour or sequence with colours and set times.
If the COLOR key is pressed, the projectors are switched on with the last set colour used.
If SEQUENCE or SPEED is pressed, they are switched on with the last sequence used.
Switching off the projectors
By pressing the key once, the projectors are switched off. The mode (colour or sequence) of the spotlights is stored so
that when they are switched on again, they will be with the same colour or sequence they had when they were switched off.
Pressing the Key of the Modulator continuously (whether the projector is on or off) puts the Modulator in the “Link”
mode to enable you to connect the Remote Control by simply pressing any key of the Control once.
