ASSEMBLY INSTRUCTIONS
CAUTION:
Do not over tighten fasteners.
A
C
C
C
Figure 1
Figure 2
Figure 3
Figure 4
PARTS & HARDWARE LIST
PART #
DESCRIPTION
QUANTITY
A Table
Top
1
B Table
Legs
4
C
Leg Connector Bracket
1
D
Table Top Support
2
E
Rubber Table Top Bumper
6
F Flat
Washer
12
G
Hex Bolts M6x25
12
H
Hex Cap
12
I Screw
M4x16
6
J Hex
Key
1
K Screw
Driver
1
4.
(FIGURE 4)
Insert the table top supports (D)
into the center fittings of the table top (A).
Secure with screws (I). Secure the table top
supports (D) to the leg connector bracket (C)
using hex bolts (G) and flat washers (F).
Carefully rotate table assembly to upright
position. Tighten hex bolts (G) with hex
key (J). Insert hex caps (H) over hex
bolt heads (G).
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
Parts Detail
1
NOTE:
This product is intended for residential, non-commercial use.
2
B
D
E
B
D
E
F
G
H
I
J
F
G
H
J
K
1. (FIGURE 1)
Insert the rubber table top
bumpers (E) into the holes located on the
top of the table legs (B) and table top
supports
(D).
2.
(FIGURE 2)
Place the table top (A) upside down
on a flat non-scratch surface. Insert table
legs (B) into leg fittings of the table top (A).
Secure the tables legs to the table top using
screws
(I).
3.
(FIGURE 3)
Place leg connector bracket (C)
between table legs (B) and secure with hex
bolts (G) and flat washers (F) using hex
key (J). Do not tighten fully.
I
K
D
I
K
F
G
H
J
A
B
D
A
B
A
B
