ASSEMBLY INSTRUCTIONS
CAUTION:
Do not over tighten fasteners.
A
B
C
D
F
G
E
Figure 1
PARTS & HARDWARE LIST
PART #
DESCRIPTION
QUANTITY
A
Table Top
1
B
Table Legs
4
C
Leg Connector Bracket
1
D
Plastic Screw Cap
8
E
Lock Washer
8
F
Hex Head Screws
8
G
Hex Key
1
A
C
F
E
B
1. Place the table top (A) upside down on a flat non-scratch surface.
2. Locate end cap leg fittings underneath the table top rim.
3. Insert table legs (B) into end cap leg fittings of table top (A).
4. Place leg connector bracket (C) between table legs (B) and secure
with hex head screws (F), and lock washers (E). Finger tighten only.
5. Carefully rotate table assembly to upright position. Tighten screws (F)
with hex key (G) in a cross corner "X" fashion.
6. Insert plastic screw caps (D) over screws (F).
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
End Cap Leg Fitting
Parts Detail
1
NOTE:
This product is intended for residential, non-commercial use.
F
E
2
D
