The mounting screws to mount the shower wand holder should already be in
place on the acrylic panel assembly. Remove them for this assembly.
1.Assemble the soap dish and the shower wand holder on the slide bar. Note
the direction of the soap dish holder relative to the shower wand holder. The
wand holder has a release button to move the holder up and down the slide
bar and this button should be facing the ceiling. On some models the release
button is in the center. If this is the case then only the orientation of the wand
holder is relevant. Please also note that the outlet spout for the hand wand
hose on the wand holder should be on the same side as the outlet for the hose.
2.Remove the screw cap cover from the end mounts for the slide bar. A
screwdriver pushing from the back side of the mount will aid in this step.
3.Apply a generous amount of sealant around the screw hole and holder and
install the lower mount.
4.Again apply a liberal amount of sealant on to the upper mount and then install
the slide bar assembly and the upper mount into place.
5.Wipe away any excessive sealant filling in any gaps.
6.Install the screw covers back onto the bar mounts.
Step 11 Install the adjustable shower wand holder
28
