Aston Global Orbitus SEN980, Инструкция по установке и эксплуатации

Страница: 8 / 23

1. Slide door stopper (1) onto end of top rail (2) See figure 1. The bumpers on door
stopper (1) should be positioned on the top of top rail for final installation. Note:
One door stopper comes pre-assembled on top rail between fixed glass bolt
assembly. See figure 1.
2. Position the top rail (2) and fixed glass (3) as shown in figure 2-1 and connect
fixed glass (3) to top rail (2) following the assembly sequence shown in figure 2-1.
An assembly tool has been included with this unit to assist with installing fixed
glass to top rail. Note in figure 2-2, one door stopper (1) should be positioned
between mounting holes in top rail (2) before connecting top rail to fixed glass.
NOTE: TOP RAIL IS ATTACHED TO THE INSIDE OF FIXED GLASS.
3. Slide the rail end (5) onto end of top (2) to be be connected to shower wall.
Loosely tighten the rail end (5) into place on top rail (2) making sure the rail end
assembly is level to the edge of fixed glass (3). See figure 3-1 and 3-2.
4. Position the top rail fixed glass assembly into place in your shower.
NOTE: THE TOP RAIL ATTACHED TO FIXED GLASS SHOULD BE POSITIONED
TO INSIDE OF SHOWER.
Using a level, verify the top rail (2) is horizontal and the fixed glass (3) is plumb.
See figure 4-1.
Using a pencil, mark the rail end (5) locations on shower wall. This will be the
drilling location to attach rail end (5) to shower wall. See figure 4-2.
5. With the fixed glass assembly in place from previous step, remove pre-installed
screw from pre-assembled glass clamp (6). Position the side of the glass clamp (6)
with shower base mounting hole on the shower base and align with large hole
opening on bottom of fixed glass (3). Mark the mounting hole of glass clamp ( 6) at
this position. See figure 5-1 to 5-3.
NOTE: If your surface is prone to cracking or chipping then it is recommended
that you pilot drill first using a smaller drill bit, and then step up to the final size.
6. Using the appropriate drill bit for your tray surface drill hole locations with 5/16"
diameter drill bit for attaching glass clamp (6) to shower base. Next insert wall
anchor into drilled holes.
Using the appropriate drill bit for your shower wall surface drill hole locations with
5/16" diameter drill bit for attaching the rail ends (5) to shower wall. Next insert
wall anchor into drilled holes.
7