7
Aston®
Overhead Two Post Lift AL-100RH User’s Manual
1. SAFETY
1.1 Introduction
Thoroughly read this manual before operating the lift and
comply with the instructions. Always display the manual in
a conspicuous location.
Personal injury and property damage incurred due to non-
compliance with these safety instructions are not covered
by the product liability regulations.
1.2 Symbols
Failure to comply with instructions could result
in personal injury.
Failure to comply with instructions could result
in property damage.
Important information
1.3 Intended Use
The lift is designed for the safe lifting of automotive
vehicles. Observe the rated load capacity and load
distribution of the lift.
Load Distribution Front
Model No.
Load Capacity
Minimum
Maximum
AL-100RH
10,000 lb.
2: 3
3: 2
●
The lift may be installed and commissioned by
authorized service personnel only.
●
The standard lift version may not be installed and
commissioned in the vicinity of explosives or
flammable liquids, outdoors or in moist rooms (e.g.
car wash).
1.5 Safety Instructions for Operation
●
Read the operating manual.
●
Lift operation by authorized personnel over 18 years
only.
●
Always keep the lift and lift area clean and free of
tools, parts, debris etc.
●
Once the disk adapters contact the lift points, check
arm restraints for engagement.
●
After raising the vehicle briefly, stop and check the
disk adapters for secure contact.
●
Always lift the vehicle using all four adapters.
●
Make sure the vehicle doors are closed during raising
and lowering cycles.
●
Closely watch the vehicle and the lift during raising
and lowering cycles.
●
Do not allow anyone to stay in lift area during raising
and lowering cycles.
●
Do not allow anyone on lift or inside raised vehicle.
●
Only use the lift for its intended purpose.
●
Comply with the applicable accident prevention
regulations.
In principle, the lift is
designed for both approach
directions.
For a long service life, we
recommend using the short
support arms for engaging
the engine side of the
vehicle.
1.4 Safety Instructions
for Commissioning
●
Do not overload the lift. The rated load capacity is
indicated on the lift nameplate.
●
Only use the vehicle manufacturer’s recommended lift
points.
●
After positioning the vehicle apply the parking brake.
●
Use caution when removing or installing heavy
components (center-of-gravity displacement).
●
The main switch serves as emergency switch. In case
of emergency turn to position 0.
